[SBE] "modifying co-ax" to drain moisture
-jer
jerhil at frontier.com
Wed Oct 3 19:00:51 EDT 2012
Q
-jer
-----Original Message-----
From: Cowboy <curt at cwf1.com>
Sender: sbe-bounces at sbe.org
Date: Wed, 3 Oct 2012 14:15:28
To: sbe member discussion mail list<sbe at sbe.org>
Reply-To: sbe member discussion mail list <sbe at sbe.org>
Subject: Re: [SBE] "modifying co-ax" to drain moisture
On Wednesday 03 October 2012 12:38:33 pm Dean wrote:
> I’m looking for a long range answer, without having to climb the tower,
> replace the co-ax, etc.
That's not going to happen.
Band-aids are exactly that.
I'd put a compressor on it and let it run, but only until you can
get a competent climber up there to seal whatever, and give
you your options for a permanent fix.
You're still going to have to run quite a bit of *dry* nitrogen through
that line to purge it properly, when it's permanently sealed.
Where are you ?
300 isn't too tall, and I can do this sort of thing.
--
Cowboy
http://cowboy.cwf1.com
SHIFT TO THE LEFT! SHIFT TO THE RIGHT!
POP UP, PUSH DOWN, BYTE, BYTE, BYTE!
_______________________________________________
The SBE Roundtable, SBE at sbe.org
To unsubscribe, go to http://seven.pairlist.net/mailman/options/sbe
http://seven.pairlist.net/mailman/listinfo/sbe
More information about the SBE
mailing list