[Techtoolslist] Fluke 9010A Input voltage

[John Robertson]

Hi Filip,

On all the 9010A's that I've seen (15 or so), on 
the rear where the international style power cord 
plugs in, there is a fuse under a plastic cover 
just below the socket. This also allows you to 
set the voltage with a slip in card.

Quoting from the 9010A Operator Manual: (find yourself a copy! or download it)

Line Voltage Selection (page 2-1)

yada, yada, yada.

1. Remove line fuse (slide cover up - JR)
2. Using a pair of needlenose pliers (see Figure 
2-2), pull the line voltage card straight out.
3. Turn the card and insert it into its slot so 
that the value if the desired line voltage is the 
upper value facing the fuse slot. In Figure 2-2, 
the card is oriented to select 120V.

John :-#)#

At 8:08 PM +0100 10/31/05, Filip Hautekeete wrote:

>Steve,

>

>There is no panel nor switch on the back. 

>However there is a note referring to the 

>manual (orientation of the mains circuit board). 

>Unfortunately I was not able to locate any 

>information about this in the service manual. I 

>was hoping someone had done this before and 

>could tell me immediately what actions to 

>perform.

>

>Best regards,

>

>Filip

>

>----- Original Message -----

>From: <mailto:steves-lists at dsl.pipex.com>Steve C

>To: <mailto:techtoolslist at flippers.com>'Technical Tools Mail List'

>Sent: Monday, October 31, 2005 7:59 PM

>Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

>

>Yes, there is a panel on the back that allows 

>voltage selection – I can’t remember how but it 

>was easy.

>

>Steve

>

>-----Original Message-----

>From: 

><mailto:techtoolslist-bounces at flippers.com>techtoolslist-bounces at flippers.com 

>[mailto:techtoolslist-bounces at flippers.com] On 

>Behalf Of Filip Hautekeete

>Sent: 31 October 2005 13:27

>To: <mailto:techtoolslist at flippers.com>techtoolslist at flippers.com

>Subject: [Techtoolslist] Fluke 9010A Input voltage

>

>Hi all,

>

>Is there any easy way to switch the Fluke 9010A 

>from VAC 120 (factory installed) to VAC 240 ?

>

>Best regards,

>

>Filip

>

>_______________________________________________

>Techtoolslist mailing list

>Techtoolslist at flippers.com

>http://seven.pairlist.net/mailman/listinfo/techtoolslist

>

>

>_______________________________________________

>Techtoolslist mailing list

>Techtoolslist at flippers.com

>http://seven.pairlist.net/mailman/listinfo/techtoolslist

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://seven.pairlist.net/pipermail/techtoolslist/attachments/20051031/10a9285c/attachment.html>