[Techtoolslist] Fluke 9010A Input voltage

[Filip Hautekeete]

Hello Rodger,

You are correct I should replace them asap. Thanks for pointing this out.

Best regards,

Filip

----- Original Message ----- 
From: "Rodger Boots" <rlboots at cedar-rapids.net>
To: "Technical Tools Mail List" <techtoolslist at flippers.com>
Sent: Monday, October 31, 2005 10:40 PM
Subject: Re: [Techtoolslist] Fluke 9010A Input voltage



> Be careful, a lot of times when you change voltage you also should 

> change the fuse.

> In the case of the 9010A the line fuse should be 1A fast blow for 120 V 

> and 1/2 A fast blow for 240 V.

> 

> 

> 

> Filip Hautekeete wrote:

> 

>> Hello Steve,

>>  

>> You are correct. Thanks to John Robertson I figured out there is a 

>> slide card for voltage selection behind the fuse panel. No need to 

>> drag the systems out of your garage ;-)

>>  

>> Thanks for your help!

>>  

>> Filip

> 

> 

> _______________________________________________

> Techtoolslist mailing list

> Techtoolslist at flippers.com

> http://seven.pairlist.net/mailman/listinfo/techtoolslist

> 

>