[Techtoolslist] Fluke Pods to Turned Pin Sockets - Help !!

Colin Davies colin.w.davies at btopenworld.com
Tue Jun 8 15:43:16 EDT 2010


Thanks John, When you say solder tail sockets.... Do you mean pressed dual
wipe type things ???

Its the tight turned pin sockets that I'm struggling to mate with.....

What I am planning to do if all else fails is.... Make up a 'stiff' assembly
of back to back IC Sockets... Wire Wrap type Turned Pin Socket Strips with
Long Legs, soldered to Vero Board, Both Sides of Vero Board will be
stiffened up, by adding a layer either side (I've got some nice insulation
resin sheet) and using some aralydyte resin to hold in place... Cut the Long
legs down, and solder a suitable socket that will take the Pod..... By
stiffening it up, it will not be prone to flexing, will last a long while ,
and be easy to remove....

I'll then use Low Cost sacrificial Pin to Pin Strips.... to plug this into
the UUT..... These can be replaced easily in sections....

I'll have some silly 'noob' 68000 pod questions to follow, lol..... So far,
I've had it testing Outrun Rams OK, but no luck whatsover with Rom
Checksums.. (on a 100% working board to get a feel of the thing)......

Cheers, Colin


----- Original Message -----
From: "John Robertson" <jrr at flippers.com>
To: "Technical Tools Mail List" <techtoolslist at flippers.com>
Sent: Tuesday, June 08, 2010 8:07 PM
Subject: Re: [Techtoolslist] Fluke Pods to Turned Pin Sockets - Help !!



> Colin Davies wrote:

>> Hi Guys,

>>

>>

>> I was playing with my 68000 pod, and wanted to plug it into an outrun

>> board with turned pin sockets....

>>

>>

>> Obviously the Pod pins are too big to go into the turned pin sockets on

>> the game board, so I used the RED socket supplied which worked nicely....

>>

>>

>> However, as soon as I removed the red socket, its started to loose its

>> pins......and after trying in a couple of other boards, its pretty

>> knackered now....and in poor shape....

>>

>>

>> Is there a fairly cheap alternative to this RED socket , before I start

>> making a fancy adaptor up using back to back sockets and replaceable

>> strips of pins...

>>

>>

>> I'm thinking IC header strips or something ? - Obviously needs to mate

>> with the Turned Pin Sockets, but accept the Fat Pod Pins....

>>

>> Any ideas appreciated please.....

>>

>>

>> Cheers, Colin

> I use 'sacrifice' IC sockets (solder tail) on the UUT end of my pods.

> Better to break off a socket leg then break off a pin from the UUT

> connector!

>

> John :-#)#

>

> --

> John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9 Call

> (604)872-5757 or Fax 872-2010 (Pinballs, Jukes, VideoGames)

> www.flippers.com "Old pinballers never die, they just flip

> out"

>

> _______________________________________________

> Techtoolslist mailing list

> Techtoolslist at flippers.com

> http://seven.pairlist.net/mailman/listinfo/techtoolslist

> FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment

> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/





More information about the Techtoolslist mailing list