[Techtoolslist] 9010 Z-80 Pod Help needed

Kevin Moore talon.k at gmail.com
Sun Mar 10 06:45:55 EDT 2013


Not saying this is it, but I've had 2 instances where I would get a 00
on selftest, and it turned out to be a bad connection on the zif
socket.

Kevin


On Sat, Mar 9, 2013 at 9:09 PM, Justin Johnson <rugd2go at comcast.net> wrote:

> Hi Guys,

>

> I'm hoping I can find some help fixing my Z-80 Pod. Here is the scoop and I

> will try to make this short. I purchased a Z-80 pod with the cables cut

> off. Found a new set of cables and tried a self test. The self test gave

> me the failure code 00. I then used a 40 pin socket and removed pin 29 as

> suggested in the manual and placed the socket on the pod pins and reinserted

> the 40 pin connector into the pod for a bus test. I then got a CTL ERR

> 00000000 00001000-LooP. As I understand it that shows an issue with driving

> bit 5. Am I correct that this is address and data line 5? I used my logic

> probe and probed the data lines of U4 or R6532AP. I found that pin 28 of U4

> which is the R6532AP has Data line 5 low while the other data lines are

> high. Where do I go from here? Any help or suggestions would be

> appreciated.

>

> Thanks

>

> Justin

> _______________________________________________

> Techtoolslist mailing list

> Techtoolslist at flippers.com

> http://seven.pairlist.net/mailman/listinfo/techtoolslist

> FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment

> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/



More information about the Techtoolslist mailing list