[Techtoolslist] Tech Tip - Protecting those Fluke POD UUT pins!

David Shoemaker davids at oz.net
Sat Apr 6 14:26:45 EDT 2013


What type of socket do you use?

I have been using turned pin sockets.

-----Original Message-----
From: "John Robertson" <jrr at flippers.com>
Sent: ‎4/‎6/‎2013 10:53 AM
To: "techtoolslist at flippers.com" <techtoolslist at flippers.com>
Subject: [Techtoolslist] Tech Tip - Protecting those Fluke POD UUT pins!

Just corresponding with a fellow about his pod that had some broken pins
on the UUT connector end and I told him how I deal with that - I use
"Sacrificial" IC sockets on the pins so the IC socket legs can be
damaged, but the POD connector is not at risk.

Also, if a pin is broken off simply strip the lead close to the UUT
connector end and run a short jumper to the sacrificial IC socket.

Figured I should share this with you good folks in case the idea hadn't
occurred to you...

John :-#)#

--
John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9
Call (604)872-5757 or Fax 872-2010 (Pinballs, Jukes, VideoGames)
www.flippers.com
"Old pinballers never die, they just flip out"

_______________________________________________
Techtoolslist mailing list
Techtoolslist at flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/


More information about the Techtoolslist mailing list