[Techtoolslist] Fluke 9010

[Chris Toseland]

Hi Martin,
 

>From memory it was a mask programmed 804x series, I'd need to strip it

down again to be 100% sure.
 
Cheers
 
Chris

	-----Original Message-----
	From: techtoolslist-bounces at flippers.com
[mailto:techtoolslist-bounces at flippers.com] On Behalf Of Martin White
	Sent: 19 November 2006 14:16
	To: Technical Tools Mail List <techtoolslist at flippers.com>
	Subject: Re: [Techtoolslist] Fluke 9010
	
	
	Chris,
	
	What's the cpu? The service manual shows "536094" but not too
sure if this is a Fluke part number or what? Is that the actual number
on the cpu?
	
	Just read through some interesting stuff on the tape drives in
the service manual so I may open mine up at some point and see if I can
work out what's up with the drive. Used to work fine until it was stored
for a few months. When it came out of storage it no longer works. Never
really bothered about it too much since I have the RS232 option but it
would be nice to get it going again!
	
	Martin.
	
	
	On 19/11/06 12:47, "Chris Toseland" <Chris at muppzlab.co.uk>
wrote:
	
	

		Hi folks,
		
		This maybe a long shot but does anyone have or can
duplicate the controller CPU for the tape drive unit on a 9010?
		My tape unit doesn't work, I've checked the sensors and
even tried driving the CPU input pins directly all to no avail so I and
can only assume that the CPU is dead.
		
		Thanks
		
		Chris
		
		
________________________________

		_______________________________________________
		Techtoolslist mailing list
		Techtoolslist at flippers.com
		http://seven.pairlist.net/mailman/listinfo/techtoolslist
		

	
	
	-- 
	Guddler's Domain
	http://www.guddler.co.uk
	
	

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://seven.pairlist.net/pipermail/techtoolslist/attachments/20061119/7d3afe44/attachment.html>