[Techtoolslist] Fluke 9100 Woes, Memory Dip Settings Needed

[David Fish]

Mark,

 Try the Service Manual Part 2, page 3-25, Table 3-6. It has the config 
switch settings for various RAM sizes.

Have a Merry Christmas All.

Dave
----- Original Message ----- 
From: "Mark Hooks" <markhooks at earthlink.net>
To: "Techtoolslist" <Techtoolslist at flippers.com>
Sent: Sunday, December 24, 2006 2:00 AM
Subject: [Techtoolslist] Fluke 9100 Woes, Memory Dip Settings Needed



>I just picked up a couple of 9100s with problems. One hangs up in memory

> test. I'm thinking it may not have the dip switch settings set up right.

> I've searched and searched but can't find the settings in the 

> documentation.

> I'd appreciate it if someone could send them to me or point me to a manual

> that has them.

>

> The second one doesn't even get that far. It hangs up with no display and

> the Run UUT and Disk Access LEDs lit. Any ideas on how to get these 

> running

> would be appreciated.

>

> Mark Hooks

>

> _______________________________________________

> Techtoolslist mailing list

> Techtoolslist at flippers.com

> http://seven.pairlist.net/mailman/listinfo/techtoolslist