[Techtoolslist] Directory success !!! (for HDR that is.)

[Andrew Welburn]

and another one comes through that was a reply to my reply that had the 
full directory quoted below! hehhehe

(I trimmed it this time!)

Andrew Welburn
http://www.andys-arcade.com

On 12/12/2012 20:34, Martin White wrote:

> I started for centipede once. I think I got all the ICs in but got bored after only a small amount of the connections. And I never really properly grasped the dividing up into functional blocks and scripting for those blocks properly. I found it hard to apply the examples to my case.

>

> Sorry for the lack of punctuation. In a bar, using my phone :)

>

> -----Original Message-----

> From: Andrew Welburn

> Sent: 12/12/2012 20:15

> To: Technical Tools Mail List

> Subject: Re: [Techtoolslist] Directory success !!! (for HDR that is.)

>

> Because when you map a UUT (unit Under Test) netlist you need to tell it

> which part is in which location and how it is connected to every other

> IC on the PCB so that it can tell operators where to move in

> back-tracing a fault in GFI mode. (Guided Fault Isolation) Every device

> on the UUT needs describing, its I/O directions etc.. Fluke provides

> most TTL and basic discretes as you can see.


[snip!]