[Techtoolslist] Tape for Fluke async clock probe

John Robertson jrr at flippers.com
Mon Jan 18 23:06:56 EST 2016


On 01/18/2016 7:18 PM, Ian Eure wrote:
> Does anyone have a good, complete dump of the tape that came along with the async probe for the Fluke 9010a? I have a console with the async clock module, and the probe, but no copy of the tape, which is needed to tun it.
>
> I've found a few dumps[1][2][3], but they all appear to be incomplete. Per the manual[4], the tape has two sides, but I don’t see any dumps of side B. All three of the side A dumps are missing programs 12-18, they only have “<BINARY>” placeholders. These seem to be the programs which actually drive the async probe, so it seems unlikely that it would operate without them. Perhaps binary data can’t be transferred via the serial port? I’ll be very annoyed if that’s the case, since working tape drives are rare and I don’t think anybody has figured out how to repair them.
>
> [1]: http://www.coinopflorida.com/fluke/9010A%20Arcade%20Scripts/async.s
> [2]: http://www.coinopflorida.com/fluke/9010A%20Arcade%20Scripts/SA-async.s
> [3]: http://www.coinopflorida.com/fluke/9010A%20Arcade%20Scripts/ASYNC-R.S
> [4]: http://arcarc.xmission.com/Test%20Equipment/Fluke/9000/9000A-006%20Async%20Probe1.pdf
>

Those appear to be downloads from the TTL FTP site. The last time I 
tried to extract the data was 2002, and as I had no real use for the 
Async I never tried again.

Look for a file called SA-ASYNC.H - that is on the TTL FTP site under 
Fluke/9010%20Scripts - I think that is the HEX file copy I made back in 
2002...note that it is stored in ASCII, so you can upload it via the 
RS-232/USB/etc port.

John :-#)#
-- 
How to subscribe or unsubscribe from TTL 
http://seven.pairlist.net/mailman/listinfo/techtoolslist



More information about the Techtoolslist mailing list