[Techtoolslist] 9100FT RTC

[William Stillwell]

I would convert the Spinny HDD to a CF Card.

Andy's Arcade has a premade 64mb CF Card Image ->

https://www.andysarcade.net/personal/tech/fluke9100/index.htm

maybe it is possible the system is failing to start because of a Disk I/O
Error?

William Stillwell





On Thu, Mar 17, 2022 at 2:59 AM Kevit Desai <kevitdesai at gmail.com> wrote:

> Thanks Tony, I have 4 sims installed, i believe 4 mega bytes, this is also
> indicated on startup. I did try swapping ,rotating and reducing the sims,
> but observed no change.
> I am not able to boot with the scsi card installed, when I remove it i am
> able to boot from the service disk and also install system software. Yes i
> did press the relevant keys in both scenarios and no success from booting
> with the SCSI installed.
> Yes the settings look correct.
> Is there a way to do a hard reset which takes the system back to factory
> settings?
> And for me to renter all data?
> I highly suspect a memory issue and therefore suspect u26 and u36, are the
> checksums available?
> --
>
> Regards,
> Kevit Desai
> Tel: Mobile: +254 722 517067
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist at flippers.com
> https://pairlist7.pair.net/mailman/listinfo/techtoolslist
> FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
>